![]() |
LIRC libraries
Linux Infrared Remote Control
|
Describes and decodes the signals from IR remotes. More...
#include <stdint.h>#include <sys/time.h>#include <unistd.h>#include <string.h>#include <math.h>#include <stdlib.h>#include "media/lirc.h"Go to the source code of this file.
Classes | |
| struct | ir_code_node |
| An ir_code for entering into (singly) linked lists, i.e. More... | |
| struct | ir_ncode |
| IR Command, corresponding to one (command defining) line of the configuration file. More... | |
| struct | decode_ctx_t |
| State describing code, pre, post + gap and repeat state. More... | |
| struct | ir_remote |
| One remote as represented in the configuration file. More... | |
Macros | |
| #define | IR_PROTOCOL_MASK 0x07ff |
| #define | RAW_CODES 0x0001 |
| for internal use only | |
| #define | RC5 0x0002 |
| IR data follows RC5 protocol. | |
| #define | SHIFT_ENC RC5 |
| IR data is shift encoded (name obsolete) | |
| #define | RC6 0x0004 |
| IR data follows RC6 protocol. | |
| #define | RCMM 0x0008 |
| IR data follows RC-MM protocol. | |
| #define | SPACE_ENC 0x0010 |
| IR data is space encoded. | |
| #define | SPACE_FIRST 0x0020 |
| bits are encoded as space+pulse | |
| #define | GRUNDIG 0x0080 |
| encoding found on Grundig remote | |
| #define | BO 0x0100 |
| encoding found on Bang & Olufsen remote | |
| #define | SERIAL 0x0200 |
| serial protocol | |
| #define | XMP 0x0400 |
| XMP protocol. | |
| #define | REVERSE 0x0800 |
| #define | NO_HEAD_REP 0x1000 |
| no header for key repeats | |
| #define | NO_FOOT_REP 0x2000 |
| no foot for key repeats | |
| #define | CONST_LENGTH 0x4000 |
| signal length+gap is always constant | |
| #define | REPEAT_HEADER 0x8000 |
| header is also sent before repeat code | |
| #define | COMPAT_REVERSE 0x00010000 |
| compatibility mode for REVERSE flag | |
| #define | REPEAT_MAX_DEFAULT 600 |
| stop repeating after 600 signals (approx. More... | |
| #define | DEFAULT_FREQ 38000 |
| #define | IR_PARITY_NONE 0 |
| #define | IR_PARITY_EVEN 1 |
| #define | IR_PARITY_ODD 2 |
Typedefs | |
| typedef uint64_t | ir_code |
| Denotes an internal coded representation for an IR transmission. More... | |
Describes and decodes the signals from IR remotes.
Definition in file ir_remote_types.h.
| #define REPEAT_MAX_DEFAULT 600 |
stop repeating after 600 signals (approx.
1 minute) update technical.html when changing this value
Definition at line 128 of file ir_remote_types.h.
| typedef uint64_t ir_code |
Denotes an internal coded representation for an IR transmission.
Note that there may be more than one ir_code in one ir_ncode.
Definition at line 43 of file ir_remote_types.h.